Zeige alle Beiträge eines Teilnehmers
1 / 1 1
Ergebnisse 1 - 27 / 27
Swen
Update. No success so far. The Beromat still overheats..
MfG
morganrue
von - by
morganrue
-
Alles rund um Musikboxen
Hallo jukebox-freunde! Ich muss in Englisch schreiben
I have a Beromat 120 (the wallmount model) and I would like to find someone who can send me a photo of the side view, so I can check the trim...
Also, does anyone know if the buttons are the same as Seeburg KD200?
Final question- did the wallmount have extension speakers?
MfG
Morgan
von - by
morganrue
-
Alles rund um Musikboxen
Thanks Hildegard.
I am puzzled that two different voltages may be used. But it’s not urgent!
M
von - by
morganrue
-
Alles rund um Musikboxen
Hallo!
Can anyone tell me the programming sequence so my Firebird will play a full cd if I press “XY 00”.
At the moment it will not accept the track number “00”
Hope you can help
Morgan in Luxembourg
von - by
morganrue
-
Alles rund um Musikboxen
Hallo forum friends, and apologies for writing only in English.
I have received a lot of advice and help from the forum in the past, so i am hoping for one just more favour! I have a virtually complete Tonmaster, with a beautifully restored mechanism, done by the world expert...
However, some of my record rings were not original, but made as copies. They are brass, and unfortunately, not d
von - by
morganrue
-
Alles rund um Musikboxen
Hello all- re: my post about the motor running hot and slow, it was the result of the 0.7 mf start capacitor failing...
All is well- happy new year!
morgan
von - by
morganrue
-
Alles rund um Musikboxen
Hello all, and all the best for 2016...
I have the most puzzling problem with my Tonmaster, and I would welcome any advice, including comments about possible causes, and even comments about things to eliminate as not being possible causes of the problem.
I have a fully rebuilt mech, and the record stack turns smoothly and freely with a gentle twist.
I have tried two different GeFaG motor
von - by
morganrue
-
Alles rund um Musikboxen
Hello again!
I sometimes think I must be insane to try to restore a Tonmaster! Can anyone help me in sourcing a Hirschmann 10 pin plug?
Or at least the top cover?
These plugs appear to be made of the rare material "unobtanium"....any advice would be gratefully received!!
Morgan in Luxembourg
von - by
morganrue
-
Alles rund um Musikboxen
Thanks to both of you for the advice.
I have placed a new wire from 24V to the credit lamp, with a 120 ohm resistor in series, and now the lamp functions perfectly.
I searched to find the original feed wire and original resistor but never found it.
I found two resistors, each on the "A" and "B" selector buttons, and a third resistor next to the diode in the credit un
von - by
morganrue
-
Alles rund um Musikboxen
Greetings once again!
I recently bought a Lyric, and am very happy with it.
I wish to have EVERYTHING working correctly if possible, and the only parts which were a problem were associated with the coin/slug rejector/credit unit. The 'box plays well, with a "free play" switch added, to advance the 20 pfg sloenoid...
I have replaced the munzprufer, and now have all three co
von - by
morganrue
-
Alles rund um Musikboxen
Hello!
Can someone help me with the following question?
On the left side of the amplifier in my Wurlitzer Lyric there are two fuses- labelled:
Si 3- 6A
and
Si 2- 0.3 A
and my amplifier stopped working today. The fuse in the 0.3A was in fact 0.4A and had blown.
What exactly does this fuse protect? Is 0.4A a satisfactory replacement, and does it being blown explain the lack
von - by
morganrue
-
Alles rund um Musikboxen
Hello jukebox friends! The problem with my "old" 1493 was related to relay number 1 being "unco-operative"!
I say "old" 1493 because today I collected my "new" 1493....Uwe Ebener had for sale a re-chromed 1493 working perfectly, and I "traded- in" my old one!
The new one looks really great,but, as usual, I have a question...
Uwe provide
von - by
morganrue
-
Alles rund um Musikboxen
Hi Charly49- I remember you from previous help, and the superb English!
Yes I checked all the "usual suspects" for connections, and also can confirm that both motors turn freely on the knurled shafts.
I will check microswitch #01 tomorrow, for conductance....
Many thanks for taking the tme to reply
Morgan
von - by
morganrue
-
Alles rund um Musikboxen
Hallo Jukeboxfreunde!
Can you possibly help me solve a problem? I appreciate your help in English!
The original fault- when changing records, the mech would stop with the record gripper part-way to the carousel. This fault was traced to the three black microswitches behind the platten, which were activated by three cams- one of the switches was not closing as the cam rotated. Jiggling the s
von - by
morganrue
-
Alles rund um Musikboxen
Hello! I would like to thank Klaus, Marc, Seeburg19, Nimko, Charly49 and above all Thierry !! After reading all your helpfull suggestions, I finally made contact with Thierry, in Luxembourg, who kindly took time from his busy schedule to visit my sick jukebox, and by careful analysis, established that the problem was as follows: when I adjusted the cam which plays on the three microswitches, I lo
von - by
morganrue
-
Alles rund um Musikboxen
Thanks Marc- I have placed the switch in scan mode, and the drum revolves as it should- but when it is back into play mode,it still turns forever! Only in the stop position does it...stop! Many thanks for your efforts!
Finally, a jukebox expert (Thierry) has offered to take a look at the mech for me. THANK YOU Thierry- I will post the results of his investigation...
M
von - by
morganrue
-
Alles rund um Musikboxen
thanks for the photos of the stand for the mechanism! I had condidered making one from wood- your ideas will be very useful! Thank!
von - by
morganrue
-
Alles rund um Musikboxen
Hallo again!
I have yet more problems with the Princess since I "fixed" it- this time I will try to describe all the events- hoping someone will have an idea...
Original problem:- mechanism stopping mid-cycle, with a record in the gripper arm, or the cycle stopping before the record was rejected.
Original solution (thanks charly49):- the three microswitches at the back of the
von - by
morganrue
-
Alles rund um Musikboxen
Many thanks Marc- I will study the manual alongside your advice, and hope to solve the problem- please also let me say a big "thank you" for such perfect English! Morgan in Luxembourg
von - by
morganrue
-
Alles rund um Musikboxen
Greetings and best wishes for 2010 especially to - charly49 in Austria for his help last month.
Please excuse again me writing in English....after fixing the 1493 (it stopped rejecting records at the end of the cycle...) by adjusting the three relays at the back of the mech- I now have A NEW FAULT- probably due to messing with the mech last month!
Now, the record drum revolves...and and re
von - by
morganrue
-
Alles rund um Musikboxen
Hallo jukebox friends! Please excuse me writing in English...
I would like to describe the fault I have, and the steps aready taken to fix it- and hope you can offer some suggestions- in time for the Christmas party!!
When the tone-arm reaches the end of the record, it often (not always) will not continue to leave the record- it just sits in the tracking groove...: I also have a remote ejec
von - by
morganrue
-
Alles rund um Musikboxen
Dear forumfriends
following the advice of Marc, I found that the motor would move manually- so after speaking the Hildegard, I bought new brushes for the motor at the Genk show- when I opened the motor- 40 years of black debris!! Lots of work cleaning it, then polishing the commutator copper ring, then cleaning the grooves between the segments- now running perfectly!! Many thanks and sorry for p
von - by
morganrue
-
Alles rund um Musikboxen
Hallo! My apologies for posting in English. Lovers of the German language would not be impressed with my German..
My Princess suddenly refused to end the record and return the disc to the carousel! Moving the tone arm manually to the "eject" point did not work...nor did pressing the "eject" button on the remote volume control.
I have looked in the relay box below the mec
von - by
morganrue
-
Alles rund um Musikboxen
many thanks for the thread, Ralf.
I also have heard that two wires on the two stepper coils can be inverted to correct this anomaly. I am waiting for detailed instructions about "how to do it" and if it works well for me, I will post the solution. Vielen Dank
Morgan
von - by
morganrue
-
Alles rund um Musikboxen
Hello! Please excuse me writing in English! If you can help, (even with a reply in German) to my problem- PLEASE DO!
I have connected a 3W1 to my Rockola Princess, and the wallbox can "talk" to the jukebox fine EXCEPT that the Seeburg takes the selection B3 and selects C2- it inverts the numbers and the letters. H4 selects D8 u.s.w!
Is this a fault, or should I re-arrange the titl
von - by
morganrue
-
Alles rund um Musikboxen
1 / 1 1