Zeige alle Beiträge eines Teilnehmers
oke sven .
So u think it the TL that causses the interference on the amplifiers .
the top TL tube is already led Tube .
So your option is to build a aluminium shield over de amplifiers .
Maybe its better to remove the ballast on de TL Unit and make it all led Tubes , without the old ballast and TL tubes .
At first i will take your info and make a shield , if that does not give the
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
thanks sven i wil try to get a netz filter en place it on the mains input .
i wil let u know if that works .
regards , nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hello jukebox fellow friends.
I have an nsm hit 120E electronic .
The amplifiers and the unit that is coupled to them have all been fitted with new capacitors.
The point here is that when the shure cartridge is not connected and the jukebox is only on, a small hum can be heard through the speakers. ( with carriage en shure same hum no differents )
So it's not a problem with the carri
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Look for the little smal iron plate that goes in to the element under the scew , if its not there u wil get a hum in the audio signal !!
Its about 2mm x 3mm with a hole in it .
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Versuchen Sie dies zuerst;
Trennen Sie die Jukebox vom Stromnetz, damit die Jukebox keinen Strom mehr hat.
Prüfen Sie zuerst, ob die Kontakte links unter dem Deckel des Schallplattenmagazins verschmutzt sind und reinigen Sie diese Kontakte mit Alkohol zwischen den Kontakten.
Zum Beispiel mit einer Kreditkarte, die man mit einem Stück Papier umwickelt und vorsichtig ohne großen Kraftaufwand zwi
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hi josef .
the translate program for German does not make sense to me ,i dont understand the problem sorry .
regards nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hi josef
because this carriage is mechanical ;
Look at the peg bank directly under the carriage and see if the pegs come up when choosing a record.
youre problem can be anything with this mechanical nightmare carriage .
Check all the cable connections first .
If the pegs dont come up when u select a record they can be dirty and stuck in down position .
regards nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hi vincent ,
The reed switch is the gray thingy with the screw right in front of the tone arm , when u unscrew it a little u can move the reed switch forward en backwoods just so u have the sweet spot u need that the switch reacts .
If that does not work maybe the reed switch is defect or the wire is disconnected .
i will try tot find a photo for you with the switch when i can .
r
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
just found a parts list for the M35 amp.
And a picture from the PCM .
maybe it can help u .
regards .......nico
NSM 35M amplifier: Elko Replacement list:
C1 = 50 uF 16V
C3 = 1 uF 35V
C4 = 50 uF 15V
C5 = 50 uF 25V
C6 = 10 uF 63V (Fitted=63V, looks the original was 25V?)
C9 = 100 uF 3V
C10 = 250 uF 6V
C12 = 25 uF 10V
C13 = 25 uF 10V
C15 = 5 uF 35V
C16 = 10 uF 25V
C17 = 10
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
christoph ,
Just order the big capacitors at Van Reichelt elektronik und techniek in germany .( they have almost anything electronik related )
Change them all it wil give better performance .
I always order from Van Reichelt and they are good !!
regards .......nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
andreas, schau auf deinem schalterplan das dritte bild das du gepostet hast.
es gibt auch an, welche Dioden verwendet werden
Grüße nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Hallo Andreas,
Ich lese schon seit einiger Zeit mit und habe eine Idee.
Es besteht die Möglichkeit, dass eine oder mehrere Dioden auf der Platine Ihrer Tastatur defekt sind.
Da viele Dioden darauf sind, ist es nicht leicht zu finden, da die Dioden auf der Leiterplatte nicht richtig gemessen werden können, ohne sie zu entlöten.
Bitte beachten Sie, dass dies nur eine Idee ist und möglicherwei
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hallo andreas,
Die anderen Männer erklärten anhand des Battrij-Tests klar, was Sie tun mussten, um den Speicherkern zu testen.
Ich kann nichts hinzufügen, die Geschichte wurde bereits klar beschrieben.
Ich denke, Sie sollten die anderen Antworten hier in Ihrem Beitrag lesen und wahrscheinlich haben Sie irgendwo etwas falsch verstanden und alles wird klar.
Grüße nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
LR 20 D-cel
Dies ist die große Version des AA-Penlite-Akkus (mehr Kapazität).
Die AA kann einfach zu wenig sein.
Grüße nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
andreas ,
Vergessen Sie nicht, dass vom 3-poligen Stecker nur 2 Stifte verwendet werden, zwischen denen Sie die D-Zelle einsetzen müssen, um die Magnetkerne zu aktivieren. Öffnen Sie den 3-poligen Stecker, um zu sehen, welche 2 Stifte belegt sind, und legen Sie die D-Zelle dazwischen. Sonst funktioniert es noch nicht.
Grüße nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Hallo allerseits ... im Bereich des Messpunktes M1 gibt es einen Widerstand von 150 kOhm und die Zenerdiode. Diese sind für den Transistor RCA 40412 und für die 135 V verantwortlich. Der RCA könnte durch 2N3439 ersetzt werden, wenn er zu Ihrer Information defekt wäre.
Ich denke nur mit und weiß bestimmt nicht alles :).
Mein Problem war mit dem gleichen Problem der Widerstand R32 und der induct
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Hallo alle ,
Dieser Text wurde von Google übersetzt, weil mein Deutsch schlecht ist und daher Fehler enthalten kann.
Haben Sie bereits die Induktoren gemessen, die sich im 300-V-Bereich befinden?LP3 (Original sind diese grün oder transparent mit kupferfarbener Farbe)
einer ist 100uh und der andere ist 130uh.
Wenn eines davon defekt ist, wird keine Auswahl gefunden.
Mit freundlichen Grüßen
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hello jens ,
thanks for the info on that .
This is the original plug on the split cable with the resistor between left channel en right channel signal on the foto .
And mono never will sound very good with the merula head , i changed it for a custom cartridge ceramic but Stereo ( sounds much better ) , so now i can only play A sides , not a problem for me because i dont play B side an
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hello jens
( The "dummy plug" )I need to switch the speakers (8 pieces) to mono.
that will probably not be the case with the consul because he only has 4 speakers ?.
But in this case it is about the amp in mono, and with me with 1 amp in mono the sound is indeed a lot of bass like yours ,with any amp.
Normally there is a resistor in the plug for the audio (the 3pin) that is pla
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hello jens,
I think the amplifiers are the same, because in my 130 stereo magic 1966 I have a 130D amplifier and 1 original 1966 amplifier. ( i have one spare original )
both are now overhauled as you know and now both play in this box with no issues in stereo .
when I put 1 amp mono with the dummy plug then you have a lot of bass indeed, but it doesn't matter which amp you put mono i
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hi Jürgen ,
Thanks for your excellent information .
I guess ill set it to 200 ohm between the violet en green wire .
Thanks to everybody on this forum that was kind enough to help me out , specially to jens who make it so easy to restore the amplifiers !!
Without this help i don't think i would get so far as i am now !!
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Thanks for the information gentlemen.
in this post "NSM Serenade Festival 130 - Frage zum Motor"
I read this information carefully, after asking you the question here if there was a setting for the adjustable resistor and capacitor.
So my statement that the engine overheated is apparently incorrect.
According to the information I have read.
The situation at the moment is that
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
all problems are solved jukebox is playing fine now !!.
regards niko
Thanks for all the help .
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
hello to everyone and i need help again " fellow jukebox fanatics "
The play motor now gets too hot about 50 degrees.
So I have another question about the resistor that drives the motor in the turntable.
The resistor is variable with a slide that is connected to the capacitor with a wire .
i now measure 172.4 ohms between resistor and capacitor.
Does anyone have an idea
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
Hello all ,
I just want to report that the amplifier is now working fine again.
Special thanks to Jens, who provided very good information about the schematics and adjustments.
without jens it probably wouldn't have worked out so well as it did .
I am A happy Camper
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen
thank you very much for your message jens, this will do everything to get it right.
great that you wanted to share this information , and I will certainly keep it very safe and well hidden , and as soon as I have time I can move on, and wil let u know what the result is .
awesome .
greetings nico
von - by
n.vandebroek@hetnet.nl
-
Alles rund um Musikboxen